There is a backup created before each coding. This can be put back in the system using the following steps:
iPhone:
- Start the app
- Connect
- Change to „coding“
- Test compatibility
- Choose the module, which should be reset
- Read coding data
- Click on „back“ (at the end of the page on the left side)
- Click „choose back-up“
- Select the preferred back-up. The back-ups are sorted from old (above) to new (below).
- Click „Load back-up“
- Click „restore“
Android:
- Start the app
- Connect
- Change to „coding“
- Test compatibility
- Choose the module, which should be reset
- Click „Load back-up“ on the right side. If “load back-up” isn’t visible, scroll down on the right side.
- Select the preferred back-up. The back-ups are sorted from old (above) to new (below).
- Click „load back-up“
- Click „restore“